Potterton Suprima 100, Installation & Service Instructions Manual

Page: 14 / 38

2. Installation - Page 14
2.1 Unpack & Prepare the Boiler
These instructions assume you have decided
on where the boiler will be located and the type
of flue system to be used.
1. Carefully unpack the boiler.
2. Do not discard any packaging until all the
items are accounted for.
3. Open the controls cover, remove the
securing screw and washer, pull off the
controls cover and put safely aside.
4. Remove two screws and washers, remove
the white front case and put safely aside.
5. Place the mounting template in the
proposed boiler position ensuring that it is
level. Minimum clearances are accounted
for on the template.
6. Mark the flue hole, remove the template
and carefully cut the flue hole through the
wall. See fig.8 for Side Flue.
7. Place the mounting template centrally over
the hole (ensure the template is level) and
mark out the two screw fixing hole
positions.
8. Remove the template and drill the two
holes using a 7mm drill.
9. Insert wall plugs and secure the mounting
bracket to the wall using three No. 12 x 2"
woodscrews.
10. Lift the boiler onto the mounting bracket,
slide both boiler securing clips over the
mounting bracket (this prevents the boiler
from being accidently lifted off the the
mounting bracket), see fig.7.
11. The third screw provided is also to prevent
the boiler from being lifted off the
mounting bracket, once the boiler is
mounted on the wall. This screw can be
replaced by an anti-theft kit see note
below.
Note: There is provision for an anti-theft
securing point (sales code: SUPKITP) which
may be used if required.