Potter PSB-10, Installation, Operation And Instruction Manual

Page: 43 / 48

PSB-10:7
PSN-106, PSN-64, PSB-10 • 5403590 • REV A • 12/09
F.C.C.
This device has been verifi ed to comply with FCC Rules Part 15,
Class A Operation is subject to the following conditions:
1. This device may not cause radio interference.
2. This device must accept any interference received including
any that may cause undesired operation.
Requirements
System must be fully tested after installation.
Intended for indoor use in dry locations only.
Separation of power limited wiring from non-power limited
wiring must be at least ¼".
Bulk Power Supply
Primary AC
120VAC 50Hz~60Hz, 5.1AMP
Min Low AC Detect 97VAC
240VAC 50~60Hz 2.5AMP
Min Low AC Detect 190VAC
Common Relays
3A @ 125VAC (Resistive)
3A @ 30VDC (Resistive)
Battery Charging
27.3VDC @ .75A
Low Battery Detect @20.4VDC
Earth Fault to Any Terminal
0 Ohms
Output Power
20.4VDC-27.3VDC @10A Non-Power Limited
Special Application RSG-DH1224
Listed Door Holder
Fuse Specifi cation
8A-250VAC Time-Lag
Install in accordance with installation manual Part Number
5403590 Rev A, NFPA 70, and NFPA 72
B
Battery -
Comm
Low Battery
AC Power
Gnd Fault
Unused Terminals, Do Not Connect
Bulk Options
Fuse
120/240 VAC
Jumper Position
GND FAULT
DETECT ENABLE
Battery connection (non-power limited).
Use two (2) 12V batteries connected in series.
Common relays are
non-power limited.
120VAC 50Hz~60Hz
240VAC 50Hz~60Hz
Connect to separate
unswitched AC circuit
LOW AC
RELAY
NC COM NO
TROUBLE
RELAY
NC COM NO
(+)27.3VDC @10A
(-) Negative
Non-Power Limited
H N G
120|240
120|240
Ground
White
Black
OFF ON