PostProcess Technologies, Inc. • www.postprocess.com • REV C | page 5
1. OPERATION
1.1 Connecting Power to the CENTI
The CENTI is delivered with an industrial power cord. Use only the power cord supplied by
POSTPROCESS
with
the CENTI. Connect the CENTI only to 110v power.
1.1.1 Power Button
The
MAIN POWER SWITCH
is located on the rear and lower
right of the CENTI. Once it is connected to 110 v power,
press the
MAIN POWER SWITCH
to the “I” or On position.
The
ON/STANDBY
button for the CENTI is
located to the left of the
Control
screen (See
Figure 2). To power up the CENTI, press the
ON/STANDBY
button. When the
Control
Screen is lit, the CENTI is on.
Figure 1. Location of Main Power Switch
Figure 2. ON/STANDBY Button
WARNING
CAUTION
Do not place the power cord in a location where it could come into contact with water or other liquid substances.
It is recommended to keep the entire power cord suspended above the floor surface.
If the CENTI appears to be malfunctioning immediately PUSH the
ON/STANDBY
button and turn off the
MAIN
POWER SWITCH
(See Figure 1.) Then refer to the Troubleshooting section of this QuickStart Guide or contact
POSTPROCESS
support for further information.
NOTE
Before connecting or disconnecting the CENTI to a power outlet or inserting/removing the power cord, ensure
the Main Power Switch is in the “O” or Off position. Insert the power cord into the slot shown in the picture below.
