Warnings
Failure to adhere to any of the warnings below could void the warranty. Read thoroughly before operating the
machine. If the machine appears to be malfunctioning in any way, immediately
Turn Off
the
POWER
button and
refer to the Troubleshooting section of this guide on page 15. If the issue is not able to be resolved, call
POSTPROCESS
for additional support.
•
Do not operate the unit without proper grounding.
•
Do not allow alcohol, gasoline or other flammable solutions near the machine. Doing so could cause a
fire or explosion.
•
Do not touch the detergent with bare skin. Use nitrile gloves, laboratory-style eyeglasses and other
necessary personal protective equipment when performing any operations including removing parts
where skin could come into contact with the detergent.
•
Do not attempt to disassemble or repair the machine.
•
Do not place the power cord in a location where it may come into contact with water or liquids.
PostProcess Technologies, Inc. • www.postprocess.com • REV C | page 4
Warnings, Cautions and Notes
Cautions
•
Connect the unit only to 110v power.
•
Use only
POSTPROCESS
detergents. Do not add any other liquid solutions to the machine.
•
Do not operate the machine without sufficient detergent in the tank.
Ventilation
PostProcess Technologies detergents are specifically formulated chemistry for maximized 3D printed support
removal efficiency. It is recommended that the equipment be located in a well ventilated room. Specific
ventilation requirements can vary widely due to size of the install room, existing ventilation (positive or negative)
and differences in individual sensitivities to airborne scents or fragrances. For more information on the safe use
of
POSTPROCESS
detergents refer to the SDS for the specific detergent used.
Caution should be used whenever working with electrically-powered
equipment. If there is an emergency situation, it is important to note
that hitting the
ON/STANDBY
button does not turn off power to the
CENTI. It turns off the operating cycle only. To shut off power to the
CENTI, turn off the
MAIN POWER SWITCH
. (For switch location, see
Figure 1. Location of Main Power Switc
h)
Detergent Safety
As noted in the safety warnings above, it is important that operators do not come into contact with any form of
detergent with bare or uncovered skin.
•
When working with or near detergents, always wear nitrile gloves.
•
Wear laboratory-style protective glasses.
•
If bare skin comes in contact with detergent, thoroughly wash the
body part with soap and warm, clean water.
•
It is recommended that an eyewash station is near the CENTI and
any detergent storage areas.
