User’s Manual for
TPL7000
Series Portable Data Terminal
22
Set Date Mode
3 2 3 3
To set Date Format: mm/dd/YY;
dd/mm/YY; mm/dd/yyyy;
dd/mm/yyyy
Basic Barcode
3 3 1
To set Basic Barcode decoder
parameter
Advanced
Barcode
3 3 2
To set Advanced Barcode
decoder parameter
Get Barcode Type
3 3 3
To decide if the Barcode Type
ID will be added to the barcode
in each scan
Pre/Postamble
3 3 3
To decide if the Preamble or
Postamble will be added to the
barcode in each scan
Note:
The information in the above table is only for reference.
2.1
.
Quick Setup
a.
When the
“Power-on Screen
”
is displayed, press
M1
and
F1
in
sequence (or
F2
, or
F3
, or
F4
) for a quick setup of the following
functions:
i.
To set beep volume:
M1
+
F1
The
TPL7000
provides 4 different volume levels: “
quiet
”,
“
low
”, “
middle
”, and “
loud
”. Each time
M1
and
F1
are
pressed in sequence, the beep volume goes from one level to
the next. It eventually goes back to the first one upon the fifth
pressing. Under this mode, however, no volume change is
indicated on the screen. The user can only sense the change by
listening to the beeps carefully.
ii.
Pressing
M1
and
F1
once will turn the volume
off (
quiet
).
iii.
Pressing
M1
and
F1
twice will set the volume at
Low
.
iv.
Pressing
M1
and
F1
three times will set the volume at
Middle
.
v.
Pressing
M1
and
F1
four times will set the volume at
Loud
.
vi.
Pressing
M1
and
F1
five times will turn the volume off again.
b.
Each time you press
M1
and
F2
in order, the “
Firmware Date
” at
the upper right corner of the display will appear for about 0.5 sec.
c.
Pressing
M1
and
F3
, the backlight is on, and press again to switch it
off.