BRX Power Injector Installation Guide
13
180-0192-001-R01
Step 6:
attach the white wire (
neutral
) to the proper
connector of the pre-installed 110-220Vac power
supply.
Step 7:
carefully remove the leftmost rubber
grommet from the enclosure of the BRX Power
Injector. You will need to lift the light grey sealant of
the enclosure to loosen the rubber grommet.
Step 8:
using a sharp box cutter or similar tool,
followed the markings at the center of the rubber
grommet and cut an opening to insert the AC Power
Cable. Make sure to minimize the size of the
opening since you will have to seal it afterward (see
step 12 below.
