Page 12
CAUTION:
Please turn off the system power first! Then hold the base and
move the terminal carefully.
Connecting Cables
To have the terminal ready for operation, please connect all required cables to
the appropriate connectors. Please make sure that each connector is connected
to the correct port with the correct orientation.
Damages due to incorrect
connection or orientation are not covered by product warranty!
Some connectors like the LAN or CR connector have to be gently inserted
until a click is heard. It is recommended that connectors such as the COM port
and VGA connector be screwed into place once seated. Please make sure that
each connector has to be connected to the right device in the right way.
CAUTION: On doing any insertion or extraction of any connector, please
always hold the connector head itself instead of pulling on the
cable wire. Failure to do this could damage the cable and jack
that is considered as an artificial destruction and is not
covered by the warranty.
Preparing the Main Unit
On the back of the I/O Plate, there is a service window among the 1 matching
screw.
Remove the service window lock screw to find several jumpers.
The
jumpers in this window are designated for
USB Touch, VGA & COM port
power and hardware reset functions. Please consult your dealer for technical
support on setup of these jumpers. Please notice that only those qualified
technicians may adjust in the service window with information from Posiflex
and the contents in the service window may change without notice as time
develops.
Before install the rear mount upgrade kits such as customer display,
there is one step needs to do. Please release the cable exit cover as following
steps:
A: Please find the back of cable cover which just near the I/O plate.
B: Please use the Fingertip to release compression lock.
C: after the cable cover released, please cut the circle part which show in the
picture C.
