POSIFLEX LS-1000 Series, User Manual

Page: 9 / 22

Beeper Indications
A beeper gives audible feedback on scanner operation.
Beeps Indication
One beep A barcode has been successfully decoded.
Four beeps in series This indicates the scanner passed the power on self-test and is
operating properly.
Two beeps: low-high The scanner has entered programming mode.
Two beeps: same tone Scanner has returned from programming to normal mode.
Continuous tone
This is a failure indication. Return the unit for repair.
SCANNER MAINTANTENCE
Maintaining the Scanner
The scanner is designed for long-term trouble-free operation and rarely
requires any maintenance. Only an occasional cleaning of the scanner window is
necessary in order to remove dirt and fingerprints.
Cleaning the Scan Window
Wipe the scan window with a soft lint-free cloth and a non-abrasive cleaner
to avoid scratching and damaging the scan window. The scan window may be cleaned
while the scanner is running.
Replacing Interface Cable
The standard interface cable is attached to the scanner with an 10-pin
modular connector. When the connector is properly seated, it is secured in the scanner
by a flexible retention tab. The cable is designed to be field replaceable.
Replacement cables can be obtained from your authorized distributor.
To replace the cable, take the following steps.
Make sure the power of both host computer and the scanner is switched off.
Disconnect the old scanner cable from the computer system.
Press down the retention tab, and gently pull out the cable.
Insert the new interface cable into the bottom of the scanner until it clicks.
Plug the new cable into the host.
TROUBLE SHOOTING GUIDE
This section contains information about how to solve problems that you may
encounter when operating the scanner. If troubles occur, please refer to the following
diagnostic tips as a mean to solve the trouble. However, before referring to the tips,
Page 9