SERVICE MANUAL
CYKLON 5000
Page 18
Service manual C
yklon - V
. 1.0 - 10-03-22 Appr
ov
ed by: JN
Place the valve housing on a drift seated
on a block. Press the valve housing down,
compressing the spring. Keep the flat part of the
valve piston parallel with the horizontal slot in the
end of the valve housing. Move the valve piston
up and down a few times to check for freedom of
movement.
Press the valve housing down and slide an
o-ring remover through the hole in the valve
piston.
Lubricate the o-ring and the thread of the valve
seat. Screw in the valve seat with an 8.5 mm
screw driver until the o-ring remover comes
loose.
Install the operating device (14). Insert the lever
pin (11) through the slot, engaging the hole in
the operating device. Rotate the lever pin 90
degrees to lock it in place.
ASSEMBLY - 2nd STAGE 1133, 3224, 3354, 3354 M, 3536
