Troubleshooting
ROBO-8910VG2A User’s Manual
5-7
Q: How can I build up an AT system using ATX power supply
A:
Yes, ROBO-8910VG2A can support system in AT mode.
Q: How to use Standard PS/2 Keyboard and Mouse?
A:
Users may always adopt PS/2 keyboard and mouse over the J21 jumper interface
(through bracket which supports PS/2 function) on ROBO-8910VG2A. (Figure
5-10)
Figure 5-10
Q: OK. I have finished hardware installation, but I got nothing when I power on
the system. Why?
A:
There are thousands of different reasons to get this power on failure.
1.
Check ROBO-8910VG2A jumper, JP1. Otherwise, incorrect power setting
will not allow you to power on the system.
2.
Double check if every connector is attached with the correct cable.
3.
If you have changed processor with different system clock, please move JP3
(CMOS clear Jumper) to 2-3, power on the system to clear CMOS (move on/off
switch from off to on for AT mode, or toggle the switch for ATX mode), power
off the system, move JP3 back to 1-2, and power on again. This way to process
the action for “Clear the CMOS Setting”.
Q: I connect two IDE devices over one IDE flat cable, but the system either does
not start, or just hangs from time to time. Why?
A:
Make sure that you have configured the two IDE devices as a master and a slave,
respectively.
