Troubleshooting
ROBO-679 User’s Manual
5-
1
CHAPTER 5
T
Troubleshooting
This chapter provides you a few useful tips to quickly get your ROBO-679
running with no failure. As basic hardware installation has been addressed in
Chapter 3, this chapter will basically focus on system integration issues, in terms
of backplane setup, BIOS setting, and OS diagnostics.
5-1 Backplane Setup
Backplane
ROBO-679 is a full-sized SBC, and therefore is able to run on any PICMG
backplane, active or passive.
ATX power
ROBO-679 is designed to support ATX powering. Please refer to the following
instruction to apply ATX power on your ROBO-679 and backplane.
Demonstration model: Backplane - PBP-14P4 / ROBO-679
Step1: Remove the jumper on pin3 and pin4 of CN4 ATX P/S CONTROL
CONNECTOR, 4-pin) connector (see the Figure below). CN4 connector
is on the lower-left side of the CN7 (ATX POWER CONNECTOR) on the
backplane.
StockCheck.com