Portwell ROBO-678, User Manual

Page: 80 / 80

5
6. Please remove this network device from system setup menu and restart
windows to re-detect your network adapter again.
7. After you are sure that hardware installation is completed, please go to
Control Panel -> Network to set up your networking configuration. This
includes DNS, IP, Gateway. Appropriate protocols are required to carry
your networking activities. Please refer to your system administrator for
additional assistance.
Windows-NT 4.0 users.
1. Please install your network adapter manually in Control Panel -> Network
-> Adapter. Drivers are required at this stage.
2. Proceed “Binding” after you load in the driver.
3. Change to Protocol label and load in the protocols that you have interest
(generally, TCP/IP). Configuring IP, gateway and DNS is required for
TCP/IP protocol.
4. Proceed again “Binding” after you complete the protocol loading.
5. Restart your system.
6. There is also situation that your installed network adapter is not working
anymore for you, or old network driver stays in the system after you
change your network card. Please remove then all the network adapters
and protocols from network setup menu and redo the loading of driver and
protocols again.
7. Network setup within Windows-NT 4.0 is not as easy as within Windows-
95/98. Special familiarity and care are required to come out with a
successful installation.
Note
Please visit our technical web-site at
http://www.portwell.com.tw
for additional technical information that is not covered in this manual.