Award BIOS Setup
51
UART Mode Select:
Options IrDA, ASKIR and Normal.
This item allows you to select UART mode.
RxD, TxD Active:
Options “Hi, Hi”, “Lo, Lo”, “Lo, Hi” and “Hi, Lo”.
This item allows you to determine the active of RxD, TxD.
IR Transmission delay:
Options Enabled, Disabled.
This item allows you to enable/disable IR transmission delay.
UR2 Duplex Mode:
Options Half, Full.
This item allows you to select the IR half / full duplex function.
Use IR Pins:
Options IR-Rx2Tx2, RxD2 and TxD2.
This item allows you to select IR transmission routes, one is RxD2m, TxD2
(COM Port) and the other is IR-Rx2Tx2.
Onboard Parallel Port:
Options 3BC/IRQ7, 378/IRQ7, 278/IRQ5 and
Disabled.
This item allows you to determine access onboard parallel port controller
with which I/O address.
Parallel Port Mode:
Options SPP, EPP, ECP and ECP+EPP, Manual.
Select an operating mode for the onboard parallel (printer) port. Select
Normal, Compatible, or SPP unless you are certain your hardware and
software both support one of the other available modes.
EPP Mode Select:
Options EPP1.7, 1.9.
Select EPP port type 1.7 or 1.9.
ECP Mode Use DMA:
Options 3, 1.
Select a DMA channel for the parallel port for use during ECP mode.
Init Display First:
Options PCI Slot, AGP.
This item allows you to decide to active whether PCI Slot or on-chip VGA
first.
Intel 82540 / 82541 Lan Boot ROM:
Options Disabled, LAN1, LAN2 and
Both Two.
This item allows you to decide whether to invoke the boot ROM of the
onboard LAN chip.
Summary of Contents for PEB-7702G2A
Page 2: ......
Page 6: ...iv...
Page 20: ...Installations 14 2 2 Board Layout Jumper Connector Location...
Page 24: ...Installations 18 2 4 Connector s Description Connector Location...
