Portwell PEB-7702G2A, Installation Manual

Page: 19 / 69

Installations
13
2.1.4 Setting Jumpers
There are jumpers on the system board of the PEB-7702G2A Series.
You can set the jumpers to make the necessary operations.
Figure 7: Jumper Connector
For any three-pins jumpers (figure 7), the jumper setting is 1-2 when the
jumper connects pins 1 and 2. The setting is 2-3 when pins 2 and 3 are
connected and so on. You could see one of the lines surrounding jumpers is
thick, which indicates pin NO.1.
To move a jumper from one position to another, use needle-nose pliers
or tweezers to pull the pin cap off the pins and move it to the desired
position.