In Commercial Confidence
13
Note that:
1)
Nothing will be changed if no any sensor ever sent ID learning request to the host during ID learn valid
period.
2)
Every successful “*
99*
#” command will be valid for only 3 minutes, so user should power on the ID learn
need sensor before the state turn into invalid. It will delay 3 minutes for another device ID learning after one
time of successful code learning.
3)
Up to 1 wireless temperature sensors can be matched with one host in one time ID learning process
B: wireless door sensor ID learning
¾
Input “*
88*
#” to enable door sensor ID learning.
¾
Power on the wireless accessory soon, the sensor will send out its ID into air and at the same time its LED will
flash.
¾
The buzzer of keypad will beep for every successful sensor ID learning.
¾
Power next device on that need to be learned till all of them are finished.
¾
Input “*
80*
#” to end door sensor ID learning, the buzzer will beep to indicate a successful operation.
Note that:
1)
Nothing will be changed if no any sensor ever sent ID learning request to the host during ID learn valid
period.
2)
Every successful “*88*#” command will be valid for only 3 minutes, so user should power on the ID learn
need sensor before the state turn into invalid. It will delay 3 minutes for another device ID learning after one
time of successful code learning.
3)
All previous ID will be cleared as soon as a same kind sensor ID learning request arrived first time, the new
ID will then be saved.
4)
Up to 4 wireless door sensors can be matched with one host in one time ID learning process
XI.
INTERNAL BATTERY PROTECT MECHANISM:
1.
To protect internal battery, we added a mechanism to TLU100N, when the internal battery voltage drop to
10.8v,TLU100N will keep to detect battery voltage for 2 minutes, if the battery voltage keep 10.8v continuously
during this 2minutes period. TLU100N will send a “battery shut down event” to server to notice user. After this
event is send out, TLU100N only can work another 30 minutes.
2.
After TLU100N goes into “battery shut down” mode, TLU100N will check the battery continuously, if the battery
charges to 12v for 2 hours, it can work again.
XII.
Two ways can be selected to use TLU100N
1.
Normal: Connect unit’s hard wire to vehicles. All the above function can be used.
2.
Simplification: No connect unit’s hard wire to vehicles. The hard wire door TG-; TG+; 1 A/D; ext. power will not
be used. Notes: if you first time use TLU100N, please press the reset button once to active built-in battery work.
XIII.
FREQUENTLY ASKED QUESTIONS:
1. Question: How can I set the unit’s system working circumstance?
Reply: User can configure the unit’s parameters by PC setup program or by remote server web page. Generally the
former is quick and the latter is convenient. Reference PC SETUP AND SYSTEM INITIATION section for more
detail guidance.
2. Question: What is tamper switch and how does it work?
Reply: The tamper switch is a special input trigger, which is designed for box open detect. A tamper switch has a
physical spring; normally the spring is squeezed by box shell of equipment, however, the spring will pop on because
its elastic force as soon as the box is open, the unit will detect this change and send out a trigger report.
