USER MANUAL
–
Portman Custom Lights P3 PIXEL
Portman Spinner
Before building a structure with Portman Spinners read and follow the safety recommendations
indicated in the Safety Information chapter.
Each Portman Custom Lights P3 PIX3L comes with a Portman Spinner that allows you to build structures
with P3s easily. Portman Spinner is a construction element designed especially for P3 PIX3L fixtures.
Using it you can build horizontal or vertical lines, arrays, circles or arcs. Portman Spinner consists of the
center plate and three arms, which can be removed if necessary. When attaching an arm to a center
plate remember to tight the screws firmly. Use only attached screws and self-locking nuts, Always use
the proper tools to tighten the screws, never tight them only manually.
Portman recommends following the rules below when building a structure with Portman Spinner.
•
Before staring any works with Portman Spinners make sure, that the surface onto which you
are attaching Portman Spinner structure can support the weight of the structure and the
fixtures;
•
Always use safety wires to secure all of the fixtures in the rig individually;
•
Never use Portman Spinner to build structures with more than 7 P3 PIX3Ls. Build more
separated structures if you want to use more P3s in a rig.
•
Always attach structures built with Portman Spinners with at least two clamps (you should
use more if needed).
•
Make sure, that all of the screws of Portman Spinner are tightened firmly before using Spinner.
Use only self
–
locking nuts to attach fixtures to Portman Spinner structure. When using wing
nut always tighten it with proper tool.
•
You can detach
one of Spinner’
s arm if your rig requires that.
