USER MANUAL
–
Portman Custom Lights P3 PIX3L
Protection against electrical shock
•
Disconnect the fixture from AC power when not in use.
•
Disconnect the fixture from AC power before any operation.
•
Do not remove the rear cover. There are no user-serviceable parts inside.
•
Always ground the fixture electrically.
•
Use only the wires attached to the kit.
•
Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault protection.
•
Do not expose the fixture to rain or moisture.
•
Replace the lamp or fuse only as described.
Protection against burns and fire
•
Never operate when the fixture is damaged or some part is missing.
•
Do not touch surface when the fixture is in operation. The exterior of the fixture can reach
temperatures up to
100°
C (
212°
F). Allow the fixture to cool approximately 30 minutes before any
operation.
•
Replace the lamp when it becomes defective or worn out.
•
Never attempt to bypass the fuse. Always replace defective fuses with ones of the specified type
and rating.
•
Keep all combustible and flammable materials (for example fabric, wood, paper) at a distance of at
least 1 meter away from the fixture. Do not cover the fixture when in operation and when it is hot.
•
Do not modify the fixture.
•
Do not operate the fixture if the ambient air temperature exceeds 45
°C (1
13
°
F).
•
Do not operate the fixture after extreme change of surrounding environment temperature. Allow
the fixture to acclimate for at least an hour before operating.
Protection against falls
•
Use only professional tripods and clamps to mount the fixture or Portman Spinner structure.
•
Ensure that the structure intended for installation can hold at least 10 times the weight of all
installed devices or Portman Spinner structure.
•
Ensure that all fixtures are attached correctly to the structure, after having checked that the housing
is firmly closed and all screws are tightly fastened and use an approved means of secondary
attachment such as a safety cable.
•
Block access below the work area whenever installing or removing the fixture.
•
Do not mount more than 7 fixtures per single structure build with Portman Spinner.
•
When building a structure with Portman Spinners ensure that each fixture is connected to at least
two Portman Spinners and whole structure is attached to mounting surface with at least two
clamps.
Protection against eyesight damage and epileptic seizure
•
Do not stare directly into the light. Never look at an exposed lamp while it is lit.
•
Provide advance notice that flash light is in use.
•
Avoid long cycles of rapid flashing light.
