Page 10
For technical questions, please call 1-888-866-5797.
Item 62567
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Replacing Nylon Line
1. Press in buttons on side of Reel (33) and
remove Reel Cover (38) and Spool (36).
Reel (33)
Reel
cover (38)
Spool (36)
button
Figure D: Reel Assembly
2. Remove all old Line from Spool.
3. Find the middle of a piece (up to 9 feet)
of 0.065″ Nylon Line.
4. Insert middle of line into groove on center of Spool.
Figure E: Insert Line
5. Wind both ends into grooves using slight
tension and following arrow direction.
Figure F: Wind Line
6. Insert Spool partway into Reel,
insert line ends through Reel holes and
pull line ends snug. Close Reel.
7. Reassemble Reel Cover onto Reel and make sure
that both buttons pop back into place.
Feeding Nylon Line
NOTIcE: To prevent damage, DO NOT BUMp REEL.
This string trimmer feeds Line
automatically when stopping.
1. Make sure area is safe
to operate appliance in,
then operate it at
full speed.
2. Release Trigger and allow Line to stop fully.
3. Line will feed slightly. Repeat as desired.
Note: Line will feed only if Spool is wound
correctly and can unwrap freely.
4. To manually feed Line, unplug the Power Cord,
press the Feed Button (34) at the base
of the Reel, and pull out the Line slightly.
Keep pushing the Button and pulling the Line
out until the Line reaches the desired length.
Adjusting Working Height
1. Loosen the Length Sleeve.
2. Adjust the Tube to the desired Length.
3. Tighten the Length Sleeve.
Angle
Sleeve
Length
Sleeve
Figure G: Tube Adjusting Sleeves
