Technical data
292
Inspection marks and declarations
of conformity
Radio Frequency Devices and Radio Communi-
cation Equipment
Radio Frequency Devices and Radio Communication
Equipment comply with Part 15 of the FCC Rules and
with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference,
and
2. this device must accept any interference
received, including interference that may cause
undesired operation.
Changes or modifications made to the equipment not
expressly approved by Porsche may void the FCC
authorization to operate the equipment.
The equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference when the equipment is operated in a
commercial environment. The equipment generates,
uses, and can radiate radio frequency energy and, if
not installed and used in accordance with this
manual, may cause harmful interference to radio
communications. Operation of the equipment in a
residential area is likely to cause harmful interference
in which case the user will be required to correct the
interference at his own expense.
These Class A digital devices comply with Canadian
ICES-003.
Cet appareil numérique de la classe A est conforme à
la norme NMB-003 du Canada.
FCC Numbers PCM
USA: T8GA270
Canada: 6434A-A270
FCC Numbers Alarm System and Passenger
Compartment Monitoring, Central Locking System,
TPMS
USA: KR55WK50138
Canada: 7812D-5WK50138
Garage door opener
United States (FCC) 47 CFR Part 15 and Canada
(ISED) RSS-Gen (English)
This device complies with FCC rules part 15 and
Innovation, Science, and Economic Development
Canada RSS-210. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference,
and (2) This device must accept any interference that
maybe received including interference that may
cause undesired operation.
WARNING: The transmitter has been tested and
complies with FCC and ISED rules. Changes or
modifications not expressly approved by the party
responsible for compliance could void the user's
authority to operate the device. This equipment
complies with FCC and ISED radiation exposure
limits set forth for an uncontrolled environment. End
Users must follow the specific operating instructions
for satisfying RF exposure compliance. This trans-
mitter must be at least 20 cm from the user and must
not be co-located or operating in conjunction with
any other antenna or transmitter.
Canada (ISED) RSS-Gen (French)
Cet appareil est conforme aux règlements dalà FCC,
section 15, et au CNR-210 d'innovation, Sciences et
Développement économique Canada. Le
fonctionnement est assujetti aux deux conditions
suivantes :
(1) cet appareil ne doit pas causer d'interférences
nuisibles et (2) cet appareil doit accepter toute inter-
férence reçue, y compris celle qui pourrait entraîner
un dysfonctionnement.
MISE EN GARDE : L'émetteur a subi des tests et est
conforme aux règlements de la FCC et d'ISDE. Les
changements ou modifications non approuvés
explicitement par la partie responsable de la confor-
mité pourraient rendre caduque l'autorisation de
l'utilisateur de se servir du dispositif. Cet appareil est
conforme aux limites d'exposition aux radiations de la
FCC et d'ISDE établies pour un environnement non
contrôlé. Les utilisateurs finaux doivent respecter les
instructions d'utilisation spécifiques pour satisfaire
aux exigences de conformité aux expositions de RF.
L'émetteur doit se trouver à 20 cm au minimum de
l'utilisateur et ne doit pas être situé au même endroit
que tout autre émetteur ou antenne ni fonctionner
avec un autre émetteur ou antenne.
Information
The manufacturer is not responsible for any radio
interference caused by unauthorized modifications to
this equipment.
Such modification could void the user's authority to
operate the equipment.
21_718_GT4_Spyder_BAL_21_WKD 982 02 21 21_KW36.20-24.21_en_US.book Seite 292 Freitag, 24. Juli 2020 11:31 11
