Page 30 Emhart Teknologies - 50 Shelton Technology Center, Shelton CT 06484 - Tel. (203) 924-9341 - Fax (800) 225-5614
Safety Data
SEAL LUBE (P/N: PSA075508P)
LUBRIPLATE
®
130-AA
Manufactured by:
Fiske Brothers Refining Co.
Phone: (419) 691-2491
Emergency: (800) 255-3924
ALVANIA
®
EP Grease 1
Prod Code: 71124
Manufactured by:
Shell Oil Products
Phone: (877) 276-7285
MSDS#: 57072E-5
First Aid:
SKIN:
Remove any contaminated clothing and wash with soap
and warm water. If injected by high pressure under
skin, regardless of the appearance of its size, contact a
physician IMMEDIATELY.
Delay may cause loss of affected part of body.
INGESTION:
Call a physician immediately. Do not induce vomiting.
EYES:
Flush with clear water for 15 minutes or until irritation
subsides. If irritation persists, consult a physician.
Fire:
FLASH POINT: COC- 400°F
Cool exposed containers with water.
Use foam, dry chemical, carbon dioxide or water spray.
Environment:
WASTE DISPOSAL:
Assure conformity with applicable disposal regulations.
Dispose of absorbed material at an approved waste
disposal facility or site.
SPILLAGE:
Scrape up grease, wash remainder with suitable
petroleum solvent or add absorbent.
Handling/ Storage:
Keep containers closed when not in use. Do not handle
or store near heat, sparks, flame or strong oxidants.
Lubriplate
®
is a registered trademark of Fiske Brothers
Refining Company.
HYDRAULIC OIL (P/N: PRG540-130)
MOBIL DTE 26
Manufactured By:
ExxonMobil Corporation
Emergency Phone: (609) 737-4411
MSDS Fax on Demand:
(613) 228-1467 MSDS # 602649-00
Shell TELLUS 68
Manufactured By:
SOPUS Products
Health Information: (877) 504-9351
MSDS Assistance:
(877) 276-7285 MSDS # 402288L-0
Distributed By:
Emhart Teknologies
Phone: (203) 924-9341
First Aid:
SKIN:
Remove contaminated clothing and shoes and wipe
excess from skin. Flush skin with water, then wash with
soap and water. If irritation occurs, get medical
attention.
INGESTION:
Do not induce vomiting. In general, no treatment is
necessary unless large quantities of product are
ingested. However, get medical attention.
EYES:
Flush with water. If irritation occurs, get medical
attention.
Fire:
FLASH POINT: 390
°
F/198.9
°
C
Material will float and can be re-ignited on the surface
of water. Use water fog, ‘alcohol foam’, dry chemical or
carbon dioxide (CO2) to extinguish flames. Do not use
a direct stream of water.
Environment:
SPILLAGE:
Soak up residue with an absorbent such as clay, sand
or other suitable material. Place in a non-leaking
container and seal tightly for proper disposal.
Handling:
Wash with soap and water before eating, drinking,
smoking, applying cosmetics or using toilet. Properly
dispose of leather articles such as shoes or belts that
cannot be decontaminated. Use in a well ventilated
area.
Storage
:
Store in a cool, dry place with adequate ventilation.
Keep away from open flames and high temperatures.
Please refer to the actual MSDS for complete safety
and handling information. These can be obtained from
the point of purchase.
