Page 16 Emhart Teknologies - 50 Shelton Technology Center, Shelton CT 06484 - Tel. (203) 924-9341 - Fax (800) 225-5614
Tool Operation
Loading the POP NUT™ onto the tool
1. Connect the air supply to the tool.
2. Thread the insert 1/4 turn onto the Mandrel.
3. Press the insert against the Mandrel as indicated and the Mandrel will spin, automatically
threading the insert onto the Mandrel.
4. Keep pushing the insert onto the Mandrel until the Mandrel stops spinning. If the insert is not
fully threaded, the setting stroke will be shortened by the gap between the head of the insert and
the Nosepiece.
Figure 9:
Loading the POP NUT™ onto tool
Installing the POP NUT™ into the work piece
1. With the POP NUT™ mounted on the Mandrel, insert it perpendicularly into the hole of the work
piece
2. Pull the trigger and hold it to install the insert
3. Keep trigger depressed until the Mandrel reverses direction and completely unthreads the
Mandrel from the insert.
4. Lightly pull the tool away from the work piece as Mandrel is reversing to disengage it from the
insert.
5. Once the tool is disengaged from the insert, release the trigger.*
Figure 10:
Setting the POP NUT™
Note:
•
Fit the flange of the insert flat against the work piece.
•
Do not tilt the tool. The tool must be perpendicular to the work piece.
OK
Not OK
Gap
PULL
Work piece
Trigger
HOLD
LIGHTLY PULL
RELEASE
