8
For example, if the user needs to clean for 200 minutes, user needs to set 3 hours and 20 minutes (3:20).
4) Press "
" to confirm and the system will automatically exit the setting status. After the setting is successful, in
the standby mode, the display will show “
”.
*****NOTICE*****
*All settings of circulation cleaning should be done in standby status.
*The circulating pump and ozone would not work during the process of setting.
*If pre-heating and circulation are working at the same time, the display will show the countdown time of pre-heating.
Exit circulation clean mode:
In the standby
status
, press “
”twice and “
”
disappears from the display.
5.5 The operation of pre-heating
All settings of the pre-heating need to be set on the standby status (the display shows "---")
1) Press "
" to enter setting status, and display shows "HTON" and "time" would flicker. The start time of
pre-heating can be set up now( diagram3).
Press "
"again to turn off the pre-heating and exit pre-heating setting.
2) Press "
"(hour) and "
"(minute) to set the start time of the pre-heating.
Press"
" to control hour (0-23)
Press"
"to control minute (0-59)
3) Press"
" to enter working setting status of pre-heating ( at least 10 minutes) and the display shows "HTDU".
Press "
" each time to increase 10 minutes, press "
" each time to increase 1 hour. (the longest working time:
19 hours and 55 minutes)
For example, if the user needs to heat for 250 minutes, he needs to set 4 hours and 10 minutes (4:10).
4) Press"
"to enter temperature setting status, and the display shows "HT-T". Press “
”to adjust the
temperature (15-42
°C
).
5) Press "
" to confirm and the system automatically exits the setting state and enters the pre-heating standby
state.
