18
TOOLS NEEDED
Screwdriver
Pipe Wrench
Materials Needed
Pipe Thread
Tape
or Sealant
Two Hose Adapters
1½” X 1½” X 1¼”
Two Sections of 1½”
or 1¼” Flex Hose
Two
Hose
Clamps
Recommended
4-8 psi Back Pressure
To avoid over or under chlorination,
replace eye ball fittings in the return
jets to a smaller or larger size to adjust
back pressure. For best results use
our pressure gauge, order part number
01-22-4000.
Apply pipe thread tape or sealant
to the threaded end of both hose
adapters.
1.
The POOL FROG
®
Cycler should always be installed
between the filter and pool (or between heater and
pool if applicable).
Base Flex-Hose Installation
Screw adapters into each end of POOL
FROG
®
Cycler. Hand tighten. Finish
tightening by turning 1 to 2 revolutions
with wrench.
DO NOT OVER TIGHTEN.
2.
Attach the filter section of flex hose to one
hose adapter and the return section of flex
hose to the other hose adapter with clamps
and tighten with screwdriver. Bi-flow valve
design allows water flow in either direction.
3.
When using a POOL FROG
®
Bac Pac,
isolating the POOL FROG
®
Cycler by
installing a
corrosion resistant check
valve
is recommended, especially if a
heater is installed.
4.
For better stability, POOL FROG
®
Cycler may be
mounted on a treated wood base using
Phillips pan
head screws.
One in front and two in back.
5.
TO POOL
PUMP
FILTER
• Never install POOL FROG
®
before the heater.
• Any additional sanitizing
equipment that is installed with
FROG
®
must be installed after
FROG
®
(never before) on the
return line to the pool.
HOSE
CLAMP
HOSE
ADAPTER
HOSE CLAMP
HOSE
ADAPTER
TO POOL
1 1/2" OR 1 1/4"
FLEX HOSE
1 1/2"
X
1 1/2"
X
1 1/4"
HOSE ADAPTER
HOSE
CLAMP
FILTER &
PUMP
