17
HOSE ADAPTER
TOOLS NEEDED
Screwdriver
Pipe Wrench
INCLUDED WITH POOL
FROG
®
CYCLER
Pipe Thread Tape
or Sealant
One 6” X 1½” TBE PVC
Nipple
MATERIALS NEEDED
One Hose Adapter
1½” X 1½” X 1¼”
One Section of
1½” or 1¼” Flex Hose
One
Hose Clamp
RECOMMENDED
4-8 psi Back Pressure
To avoid over or under chlorination,
replace eye ball fittings in the return
jets to a smaller or larger size to adjust
back pressure. For best results use
our pressure gauge, order part number
01-22-4000.
Filter Flex-Hose Installation
Apply pipe thread tape or sealant
to each threaded end of nipple.
Screw one end of nipple
into the filter return.
1.
2.
Hand tighten. Finish tightening
by turning 1 to 2 revolutions
with wrench.
DO NOT OVER
TIGHTEN.
Screw either side of POOL
FROG
®
Cycler on to open
nipple end until upright
and secure.
Apply pipe thread tape or
sealant to threaded end of
hose adapter.
3.
4.
Screw adapter into the other
side of POOL FROG
®
Cycler.
Hand tighten. Finish
tightening by turning
1 to 2 revolutions
with wrench.
DO NOT OVER TIGHTEN
.
5.
6.
Attach return section of hose to
the adapter with clamp. Tighten
clamp with screwdriver.
7.
When using a POOL FROG
®
Bac Pac, isolating the POOL
FROG
®
Cycler by installing a
corrosion resistant check valve
is recommended, especially if a
heater is installed.
