7-3
7 Technical Specifications
AUX OUT
7.2.3
Metrological Properties (PSV-500-3D Standard)
DV-04 Digital Velocity Decoder
Table 7.1:
Metrological properties of the DV-04 decoder for PSV-500-3D Standard (1 of 5)
Compatibility:
TTL / CMOS
Output voltage HIGH:
min. 2.4 V (I
out
= 5 mA)
Output voltage LOW:
max. 0.4 V (I
out
= 2 mA)
Full scale value (peak)
1
2
5
mm/s
Scaling of analog output
0.25
0.5
1.25
Frequency range
f
min
0
0
0
Hz
f
max
10
20
50
kHz
Max. acceleration
6.4
25.6
160
g
Frequency response
1
1
The frequency response defines the frequency-dependent amplitude error, referred to the reference frequency of 1 kHz.
±0.1
±0.1
±0.1
dB
Resolution analog output
0.038
0.076
0.19
µm/s
Resolution
2
2
The noise-limited resolution is defined as the signal amplitude (rms) at which the signal-to-noise ratio is 0 dB with 1 Hz
spectral resolution, measured in a distance of 0.5 m on 3M Scotchlite™ Tape (retro-reflective film).
Frequency-dependent
3
3
The attainable resolution is frequency-dependent and is specified for frequencies above 10 Hz. In the frequency range from
10 Hz to 5 kHz the specified decoder noise is superimposed by the scanner noise. The resolution is then between 0.1 and
1.0
μ
m/s with 1 Hz spectral resolution.
0.01
0.01
0.01
typically
4
4
The typical value refers to the center of the operating frequency range.
0.01
0.01
0.01
Calibration error analog output
5
5
Conditions: sinusoidal vibration, f = 1 kHz, amplitude 70% of full scale range, load resistance
≥
1 M
Ω
T
a
= +5 °C…+40 °C
(T
a
= 41 °F…104 °F)
±1.0
±1.0
±1.0
%
Linearity error analog output
6
6
The linearity error is defined as the amplitude dependent, relative deviation of the scaling factor referred to the scaling factor
under calibration conditions (refer to footnote
).
0.5
0.5
0.5
%
Harmonic distortions
7
7
Harmonic distortions are specified up to 70% of full scale for the wanted signal.
< -44
< -46
< –48
dBc
Spurious signals (non-harmonic)
8
8
The maximum amplitude of the distortions refers to the full scale.An exception of this is just a peak in the frequency range
20…25 kHz and its multiples. This peak is generated by the laser in the optical sensor, the amplitudes depend on the stand-off
distance. The CoherenceOptimizer can cause interferences at a frequency of 610 Hz and harmonics.
< -60
< -60
< -64
dBFS
Summary of Contents for PSV-500-3D
