POLYPRINT SA – TEXJET OPERATION MANUAL V6.4 EN
- 18 -
3.3.
User handling of the printer
Printing with TexJet
•
Start up: The startup procedure will take about 1 Minute.
•
NON GENUINE: When you get the message, non genuine cartridge:
1. Press the DOWN button 5 times, and the display will show “Yes No”.
2. Press the LEFT button 1 time to choose “Yes”, and it will show “damage
from”.
3. Press the “DOWN” button 5 times, and it will show “Acpt. Decline.
4. Press the LEFT button 1 time to choose “Accept”. “Please wait” will
appear.
5. After 1 minute the message “READY” will appear to the display.
6. The machine is ready to print now.
•
Wait for ready: Wait until the message in the display shows “Ready”.
The ON LED (16) will stop flashing and remain on.
If you get any other message refer to the Troubleshooting chapter.
•
Preparing a shirt: Move the plate to the front position by pressing Eject
button (25) and place a Shirt. You can use spray adhesive on the plate to
make it slightly sticky or you can use the frame plate. This ensures the
Shirt lays flat on the media plate.
•
Adjust the plate height by pressing Automatic plate height adjustment
button (21) and wait until it stops with the plate at the front. Press the IN
button 26 or 27 to send the plate back
•
If the Epson Panel is not on “ready” and the height limitation LED 22 is
lightning, move the plate down, by pressing the “Go down” button (20)
until the Limit LED 22 switches off and press the IN button 26 or 27
again. Do these steps until you get “ready” on the Epson Panel display.
•
Once the plate height is defined for a kind of T-shirt a readjustment is not
necessary until the T-shirt type changes.
•
Ready to print: When the printer shows the message “READY” on the
display you are ready to print.
