PH03 Comfort Inn - September 2008
Page 11 of 12
Place the toilet seat on the top of the tank. Line up the holes in the hinge of the seat with the holes in the top of the
tank. Insert the seat bolts through the seat hinge and through the tank. Lift open the seat, thread the plastic seat
nuts on the ends of the bolts and tighten.
Step 13.
Toilet Seat Installation
Push the spring tube assembly with the swaged ball into the molded pocket. Place the door closure retainer clip on
the door over the end of the spring tube assembly and rivet into place with (2) PC-000105 rivets. Line up the cable clip
in the center of the door jamb to the door closure retainer clip. From inside the unit using a 13/64” bit, drill two holes
into one side of the door jamb only. Rivet the cable clip to the door jamb using (2) PC-000102 rivets. On the inside
of the unit, place the top of a hammer against the cable clip. Place the ball end of the spring cable in the claw of the
hammer. Open the door while holding the hammer in position. Hold the door open with your foot and clamp a vice-
grip pliers on the cable where it comes out of the door.
BE SURE TO CLAMP DOWN TIGHT
.
Remove the cable from the
claw of the hammer, close the door and place the end of the cable into the slot of the cable clip. Open the door and
remove the vice-grips.
Step 14. Door Closure Installation
PC-000105 Rivet
2 Used in this step
PC-000102 Rivet
2 Used in this step
