Wrap the parcel to be bound with the strap, as shown in
(pic.C1)
, (make sure that the strap is clean, and oil and grease
free); align the two straps and insert them between the body and bottom plate, against the front / rear strap guides
(pic.C2),
push lever 1 one time to cut and weld the strap.
(pic.C3)
. Remove the tool.
( C1 )
( C2 )
( C3 )
WARNING : Wait 2-3 seconds after the welding cycle to cool the strap before releasing it
Seal check
A regular seal quality control is very important and it can be checked visually as follows:
(D1)
(D2)
(D3)
DISCONNECT TOOL FROM COMMPRESSED AIR LINE BEFORE PERFORMING ANY SERVICE
Periodically clean the tool from strap dust, particularly the gripper plates and the cutter using compressed air.
(Do not use other tools or keys)
(pic. E)
(E)
6) OPERATION
NO
– seal strength insufficient
Weld time too short
YES
-- right
NO
– seal strength affected
Weld time too long