From the underside of the table,
look through the two holes, one in
the center post and the other in the
table joiner. Carefully slide the
bumper until you can see the nut
inserts. Fig. 30 shown in
transparent mode.
Using an 8 mm x 60 mm screw
with a LARGE washer, put a
screw up into the hole in the center
post, then on into the bumper
insert. Repeat with a similar screw
through the table joiner into the
bumper insert. Fig. 31 & 32. Do
not cinch them up yet.
Repeat for the other three
bumpers.
Fig. 28
Fig. 29
Fig. 31
Fig. 32
Page 13
Fig. 30