B
B
L
L
O
O
W
W
F
F
U
U
N
N
C
C
T
T
I
I
O
O
N
N
This function is recommended for collecting
scattered quantities of light waste such as lea-
ves, confetti and so on.
Open the air outlet grill (
8
) as described in the
“Replacing the air outlet filter”, insert the flexi-
ble tube in its place (fig. 14) and switch on the
vacuum cleaner.
U
U
S
S
I
I
N
N
G
G
T
T
O
O
O
O
L
L
S
S
Tools may be connected directly to the hose
(
D
) or to the telescopic tube (
A
).
Using the telescopic tube (A)
The tube is about 60 cm long when closed, 1 m
when extended to its greatest length. To in-
crease or decrease length, press the spring
button positioned as shown in fig. 6 and extend
or reduce length as desired.
Using the joker brush (B)
The Joker brush may be used to vacuum up
solids or of liquids on any kind of surface.
Using the parquet accessory (B1)
Position the Joker brush (
B
) on the parquet ac-
cessory (
B1
) as shown in figure 13. Apply the
tool to the brush, following the direction of the
arrow so that it is aligned properly and they
connect together.
To release the parquet accessory from the
Joker brush, pull the two levers on the sides of
the frame outward and lift the brush (fig.13a).
Using the universal brush (C)
Connect the brush to the telescopic tube. If you
move the selector on the brush (
C1
) pressing
with a foot, you can change the suctioning sur-
face without bending down. The position with
bristles extended is recommended for all non-
carpeted floors.
The position without bristles is recommended
for carpets.
Multipurpose nozzle (E)
The multipurpose nozzle is recommended for
cleaning upholstery surfaces such as the joints
of sofas, armchairs, mattresses, car upholstery,
etc.
Lance for cleaning corners/skirting boards
(F) – radiator brush (L)
The lance (
F
) is recommended for thorough
vacuum cleaning of hard-to-reach spots such
as skirting-boards and folds in sofas, arm-
chairs, upholstered furniture and car uphol-
stery. Apply the radiator brush (
L
) to the tip of
the lance (
F
) to clean inside radiator elements
and remove accumulated dust.
Soft brush (G)
The soft brush has soft bristles for dusting deli-
cate surfaces such as picture frames, books,
etc.
Using the accessories holder (H) and the
accessories holder hook (11)
The accessories holder may be used to fas-
ten tools onto the body of the appliance or the
handle.
Installation on the handle:
Hook one of the accessories holder rings to the
handle. Insert the tools you want to keep within
reach in the rings (fig.12).
Installation on the appliance body:
Slide the accessories holder guide into the
groove on the back of the appliance as shown
in figure 11, proceeding to anchor the tools as
described above. You may perform the same
operation to store the universal brush (
C
) with
the telescopic tube (
A
) attached to it.
Using the flexo joint (I)
This special joint allows you to reach hard-to-
reach spots without bending down. Insert the
Flexo joint between the flexible tube and the te-
lescopic tube, holding the notch on the front
part of the handle. To change its inclination, ro-
tate the cursor (
Y
) (fig.10) by a half turn. The
joint that allows you to alter the working
angle of the tube will then appear (fig.10). Put
the joint back in its original position when you
have finished, and cover it with the cursor to
lock it in place.
A
A
U
U
T
T
O
O
M
M
A
A
T
T
I
I
C
C
C
C
A
A
B
B
L
L
E
E
W
W
I
I
N
N
D
D
E
E
R
R
Before putting the vacuum cleaner away,
rewind the power cable by pressing the button
(
2
), as shown in fig.7, being careful to accom-
pany it during winding.
LECOLOGICO AS810
39
E
E
N
N
G
G
L
L
I
I
S
S
H
H
LECOLOGICO AS810 M0S08538 1O09 8 LINGUE:Layout 1
29/09/2008
11.07
Pagina 39
Summary of Contents for LECOLOGICO AS810
Page 1: ......
