plug(1).
- Connect the charger plug to an easily acces-
sible mains socket.
- The red LED power/charging light will begin
to flash. When the LED stops flashing (after
about three hours), the appliance is charged
and ready to be used (2).
1.2 SPRAY BOTTLE
Use the handy water sprayer to clean desired
surfaces.
- Fill the bottle with water or, if desired, non-
foaming household glass cleaner .
- Screw on the spray bottle and insert the
cloth (3).
- Turn the dispenser spout to the ON position.
- Spray the surfaces to be cleaned from a di-
stance of about 20 cm and wipe with the
cloth.
- After use, turn the dispenser spout to the
OFF position.
2. USE
2.1 Be sure to follow the instructions in Sec-
tion 1.
2.2 Install the appliance's cleaning nozzle. To
attach the cleaning nozzle, simply connect it
to the appliance (4) and then turn it clockwi-
se (5). Complete the steps above in reverse
order to remove it.
2.3 After washing the surfaces to be cleaned,
turn the appliance on by pressing the switch
(6). The red LED power/charging light will
turn on (2).
2.4 Place the window cleaning nozzle on the
upper part of the window and, using slight
pressure, move it downwards to suck dirt and
water from the surface.
2.5 Repeat this action until the surface is
clean.
2.6 When finished cleaning, turn off the ap-
pliance by pushing the button
(6).
3. EMPTYING THE DIRT
COLLECTION TANK
Empty the tank before it reaches the maxi-
mum level of dirty water.
3.1. Turn the appliance off.
3.2 Open the tank cap (7).
3.3 Tilt the tank to allow the dirty water to co-
me out.
3.4 Close the tank cap again.
4. GENERAL MAINTENANCE
Before performing any maintenance, make
sure that the appliance is switched off and/or
disconnected from the mains.
To clean the outside of the appliance, use a
damp cloth and tap water only.
Clean the cleaning nozzle with running water,
allowing it to dry completely before using it
again.
Do not use detergents of any kind.
Follow the instructions on the label when wa-
shing the cloth provided.
Empty the dirt collection tank after every use.
To clean the dirt collection tank, fill it with wa-
ter and rinse.
WARNING: If the maximum water level (8) is
exceeded, water can leak from the vents.
Always empty the tank before the maximum
water level is reached.
Once the battery runs out, the appliance will
stop working, and the LED power/charging
light will turn off. It is possible to clean up to
80 m2 of surface with a fully charged
battery.
It is normal for the charger to heat up during
charging.
For the best results, do this over a sink.
E
N
G
L
IS
H
| 22 |
