POLMAR Mini PMR446, User Manual

Page: 40 / 53

40
the transceiver will continue to keep the channel within the delay
time until the signal disappears, then the transceiver will return to
scan state. (Factory default 3 seconds).
B Start-up scan
Long press [SCAN] about 2 seconds to start scanning. From cur-
rent frequency scan the frequency one by one in increase step.
Yellow light will flash.
When such channel receive the signal and the command is ma -
tched, the yellow light will keep showing and squelch will be off.
Press [SCAN] key to exit the scan state.
C Priority scan
The dealer or manufacturer can use Easy software to set 2 kinds of
priority scan. Set the fixed channel as prior scan channel, notice:
the channel can not be empty.
Set the selected channel as prior scan channel current working
channel is prior scan channel).
If you have already set the priority scan channel, when fail to re -
ceive the matched signal during scanning, it will return to scan the
prior channel while scanning every channel. When current channel
set as the priority channel, LCD will appear PRI icon.
D Return channel
During scanning, press [PTT] key, the transceiver will transmit by
the following 4 modes.
Select: During scanning, the transceiver will transmit from main
channel (the working channel is set as the main channel)
transmit: During scanning, when receive any matched
signal in such channel, then the scan will stop for a short time
and transmit from this channel. Otherwise it will transmit from
main frequency.
Priority: During transmitting, it will transmit from the prior chan -
nel that was programmed before.
Pr transmit: During scanning, when receive any matched
signal in such channel, then the scan will stop for a short time
and transmit from this channel. Otherwise it will transmit from
the prior frequency.
After transmitting, the transceiver will turn back to scan mode
within the delay time which has been programmed by dealer or
manufacturer.
a.
b.
c.
d.