9
2
nd
IGN / ACC / CRANK RELAY OUTPUT
The PS-5565TW series car starters are equipped with a high current, programmable 5
th
relay onboard that
can be used to power a second ignition, accessory, or crank wire.
The unit uses a series of 3 jumpers; each jumper represents a function. In order to activate any one of the
three possible 2
nd
outputs, you must place the jumper (supplied) on one of the three pins and simply
connect the 14-awg wire to the vehicle’s second IGN / ACC / CRANK wire.
NOTE:
ONLY ONE OF THE THREE JUMPERS CAN BE USED AT ONE TIME.
PROGRAMMING A TRANSMITTER
The PS-5565TW transmitter does not come pre-programmed and must be code learned after the wiring of
the module is complete. The system has the ability to learn up to 4 different transmitters, if a fifth
transmitter is learned the first transmitter in memory will be lost. To erase all transmitters from memory
you must perform a module reset.
To program a new transmitter do the following.
1. Ensure the system is NOT in VALET mode.
2. Turn the key to the IGNITION position. (RUN)
3. Raise the HOOD.
4. (From OFF position) Turn the VALET switch ON, OFF, ON. (PARKING LIGHTS should
come ON solid)
5. Press LOCK button on the transmitter for 2 sec.
6. Now immediately press and hold LOCK again, until the transmitter LOCK icon gives you 1
flash and a beep
.
7. Turn the Valet switch to OFF.
*NOTE:
1. L.E.D follows PARKING LIGHTS in all modes.
2. The system can hold a maximum of 4 transmitters in memory.
NOTE
: The relay output rating on this unit is 25-amp max output. Defective OEM solenoid switches can
sometimes draw up to 50 or 60 amp, causing the 30-amp fuse to blow. Check starter wire for voltage
draw when vehicle is cranking with a digital voltmeter.
