132
TROUBLESHOOTING
EDGE 136 Suspension
Problem
Solution
Rear suspension bot-
toms too easily
• Increase torsion spring preload
• Increase rear shock compression damping by turning
screw clockwise
• Increase torsion spring wire diameter (see your dealer)
Rides too stiff in rear
• Check for binding suspension shafts and grease all pivot
points
• Decrease torsion spring preload adjustments
• Decrease rear shock compression valving by turning
screw counterclockwise)
• Check for proper track tension
Machine darts from
side to side
• Make sure skis are aligned properly
• Make sure spindles and all steering components are free
turning
• Make sure skags are straight on skis
• Check rail slide and replace if worn
• Reduce ski pressure:
A) Increase front track spring preload
B) Reduce IFS spring preload
C) Reduce rear torsion spring preload
Front end pushes
• Check for worn skags
• Check for binding suspension shafts and grease all pivot
points
• Increase IFS spring preload by adjusting cam or threaded
adjuster
• Adjust RRSS to a higher position
Steering is heavy
• Check ski alignment
• Check skags and skis for damage
• Reduce ski pressure:
A) Increase front track spring preload
B) Reduce IFS spring preload by adjusting cam
C) Reduce rear torsion spring preload
• Make sure spindles and all steering components are free
turning (elevate machine to check)
Too much weight
transfer under acceler-
ation
• Rotate RRSS to a higher position. See page 41.
Not enough weight
transfer under acceler-
ation
• Move RRSS to the rearward upper hole on high position.
See page 41.
