Polaris SUNNY THERM, Instruction Manual

Page: 24 / 34

22
(6-2) Idle program
This program is for heating the furnace temporary or drying the
Muffle of the device. For this purpose, it is sufficient to follow the
blow:
The word Idle means unemployment and it is used for keeping
the furnace warm in the time of unemployment. The duration of
implementing this program completely is 10 minutes. For furnace
planning in Idle phase, first press the Idle key and then by pressing
If you look at the left side of the graph, you can see that
by implementing each phase of the program, a small flicker of
lights shows the status and stage of the running program.
For example, if the furnace is warming to reach Stage1, a small
light blinks Heat Rate1.
After reaching the final stage STAGE3 temperature and
elapsing Hold Time3, for 10 seconds the alarm is heard,
it shows that the work is ready.
Therefore, for using the cylinder and performing CASTING,
furnace temperature will be automatically on the final heat for
60 min in order to let the operator enough time to perform the
operation, in this while and every 15 minutes a voice will be
heard and after passing 60 minutes the light of Cycle Complete
turns on and the furnace temperature starts cooling down. It
should be noted that the final stage of 60 minutes can be
hindered and stopped by pressing the Stop button.
In order not to use the first and second stage of the two
stages zero can enter numbers
As a result, the furnace will work with the third stage.
Therefore, in the third step should be taken STAGE 3
However, the parameters of both the first and second
zero can be entered.