Polaris SUNNY THERM, Instruction Manual

Page: 19 / 34

17
Sunny Therm
Pre-heating Furnace
Upon receiving the product, make sure it is intact. If there is any
damage or shortage of parts, inform Polaris Company and its
carrier.
It is recommended that the original box is kept because it is
needed for transporting the furnace safely. Also the box
ensures the claim that a safe box has been used during
transporting which prevents damage to the device.
Installation and Set up the Device
1
Take out the device carefully from its package. To do this,
all of the surrounding protectors (EPS) are removed. Then,
bring it out by taking the “bottom” of the furnace.Put it on
the quite stable, flat and standard laboratory table. It is bet-
ter to be a minimum 20 cm of empty space around the
furnace. Note that the base or the surface of the table should
not be made of metal.
If the base of the table is made of metal and in contact with
the ground, There will be a risk of electric shock. So make
sure your furnace is placed on a wooden or fiberglass table
one or make sure that the earth wire is connected to the
installation area.
2
Make sure of the resistance of the surface below the device
against the heat. The surfaces sensitive to heat may lose
their color by heat.
3
when there is not earth well, the earth wire of the
device can be connected to the nearest heater tube (if
it is made of metal) or water tube (if it is made of metal).
4
Keep the device away from direct sunlight.
5
Do not put objects or flammable substances next to the
device.