Polaris Slingshot R 2020, Owner'S Manual

Page: 33 / 173

TOGGLE BUTTONS
Press and release either toggle button
t
to cycle through the options menu or
Area 2 modes. Press and hold either toggle button to reset an item. See the
Gauge Settings Menu section for details.
TIP
With the ignition off, pressing the MODE button or either toggle button will
power up the Rider Information Center for 10 seconds to allow viewing of the
odometer and the clock.
INDICATOR LAMPS
LAMP INDICATES CONDITION
Cruise Control
Enabled
Before using the cruise control, read the safety and
operation procedures. See page 28.
Cruise Control
Engaged Before using the cruise control, read the safety and
operation procedures. See page 88.
Anti-Lock
Brake System
Your dealer can assist if this lamp remains on. When the
lamp is illuminated, the anti-lock brakes will not activate,
but the conventional brake system will continue to operate
normally.
High Beam
This lamp illuminates when the headlamp switch is set to
high beam.
Turn Signal /
Hazard
Signals
The turn signals are located at the top center of the
instrument cluster. Arrows flash when either a turn signal or
the hazard signal is activated.
If a lamp fails, or if there is a
short circuit in the signal system, the lamp flashes at more
than twice the normal rate.
Low Fuel
This lamp illuminates when approximately one gallon (3.8
liters) of fuel remains in the fuel tank.
Hot Engine
This lamp illuminates to indicate an overheated engine. If
the indicator flashes, the overheating condition remains,
and the system will automatically reduce engine power.
Check Engine
If this lamp illuminates while the engine is running, promptly
contact an authorized dealer or another qualified person
who can assist with diagnosis.
If abnormal engine
operation is detected the light will remain on as long as the
31
FEATURES AND CONTROLS