P/N 9926740 Rev 01 06/15 Page 8 of 12
REMOTE SOCKET INSTALLATION:
Washer Bottle
Approximate
Grommet Location
2. Locate the area where the wire harness and hose
will pass through the front dash wall. On MY13
vehicles a grommet is already installed. For MY14
it is a round area of 1 11/16” diameter that must be
removed by cutting along the perimeter scribe line
with a sharp tool. Remove the round plastic cut out
as shown in figure.
3. Install the grommet (PN 5414440).
IMPORTANT:
Vehicle hardware kit contains the
grommet.
4. Cut the grommet (PN 5414440) to allow wire
harness through.
1. Install remote switch on vehicle dash. Use a
1 1/16” drill bit to cut a hole centered between
dots embossed on dash. Drill two holes for screws
with 1/4” drill bit over embossed dots as shown in
figures.
1 1/16” Hole
1/4” Hole
