Polaris PVCR 0833 WI-FI IQ HOME, Operation Manual, Page: 30 / 140

30
- Check for foreign objects stuck in the channels Remove them if necessary (Fig. 7)
- Turn over the container
- Open the lid of the container by releasing the latch
- Shake the debris out of the container, first remove the filter and HEPA filter to clean or replace
- Wash the HEPA filter after 15-30 days of use, depending on the intensity of use. Use the HEPA filter for no
more than 6 months, then replace.
- Dry the filters before installation (Fig. 8)
- Install the filter elements (Fig. 9)
- Close the container and reinstall it.
CLEANING AND EXTERNAL MAINTENANCE OF THE DEVICE
1. Before cleaning, make sure that the device is unplugged from the charger and that the charger is unplugged.
2. Do not immerse the device and charger in water or other liquids.
3. Do not use gasoline, alcohol or chemical solvents to clean the appliance.
4. Wipe metal parts with a clean, dry cloth.
5. Wipe the plastic parts of the appliance with a damp, wrung cloth. There should be no drops of water.
6. Keep the device in a cool, dry place.
Cleaning infrared sensors
Gently wipe the sensors with a soft cloth, without mechanical impact.
Side brush cleaning
1. Check for any damage and/or foreign substances in the brushes.
2. Wipe the brushes with a cloth dampened in warm water and wrung out well.
3. In case of damage to the side brushes, replace them in a timely manner.
Cleaning the main electric brush
The electric brush is designed to collect household dust from the floor and carpets using a rotating bristle roller.
Its design is very sensitive to clogging with long hair, fur, threads, etc. In the event of clogging, stop using the
vacuum cleaner immediately and take measures to clean the bristle roller.
The roller has a separate electric drive which is turned on simultaneously with the vacuum cleaner motor.
To clean the roller:
1.
Turn off the device with the I/O switch (put it in the O position).
2. Turn the vacuum cleaner upside down and place it with the back toward you.
3. At a small amount of hair and threads wound around the bristle roller, they can be cut with a knife without
removing the bristle roller. To do this, place a sharp knife between the rows of bristles with the cutting edge
outward from the roller, and cutting along the roller cut the coiled hair and threads. After this, the hair cuts are
easily removed outward from the brush body, for convenience, it is allowed to rotate the bristle roller around the
axis of its rotation manually.
4.
In case of severe clogging of the bristle roller, remove the frame for attaching the electric brush roller for
which slightly press the tabs of the latches of the latch away from you and raise the near edge of the frame, and
then remove the frame.
5.
Lift the right side of the bristle roller by pulling to the right, disengage it from the drive and remove it
from the socket. When the bristle roller is removed from the body, it can be easily cleaned of coiled hair and
threads with a sharp knife or scissors.
6.
Put the bristle roller into place in the brush body in the reverse order.
7. In case of severe clogging of the brush and the drive parts, contact an authorized service centre for
disassembly and cleaning.
The works related to cleaning the vacuum cleaner components are not included in the warranty service.
TROUBLESHOOTING