28
PREPARATION FOR WORK
Unpack scooter
Make
sure that all its parts are available
(see “Description of kick scooter”) and
are not damaged.
Stickers
Remove all stickers from the device
body.
Check the battery
Before use, ensure that the battery is fully
charged (see section “Operation procedure”).
OPERATION PROCEDURE
Attention!
Before start of movement of the kick scooter, carefully study section “Technical safety”, and also section “Operation
procedure”.
Preparing scooter for work
After unpacking scooter, place it in the working position and place handles of a
wheel on it.
-
To unfold scooter, press and move locking lever in the direction of
the arrow (Fig. 1), and then place scooter in working position until a
characteristic click (Fig. 2).
To fold scooter – at the same time press locking lever and gently
push the wheel of the scooter forward in the direction of travel – the lever can
be moved freely in the direction indicated by the arrow (Fig. 1). Fold the scooter.
At the end of the turn, a characteristic click will again sound and the scooter will
move to transport and storage position.
To install the handles on the wheel, screw them in the direction
of the arrows (Fig. 3). Tighten the handles to hold them securely.
Attention! Before installing the handles, determine which one is left and which is right,
in the direction of the thread. Note that the right handle (in the course of movement of
the scooter) has a left thread, and the left one - the right thread.
Before you start, you must perform the initial full charge of the
battery.
The charging port is located on the supporting platform on the left in the
direction of movement of the scooter (Fig. 4). Remove the protective cap and
insert charging wire, then insert charger into the outlet. The charge indicator
will turn red until fully charged. When charging is completed, the indicator will
turn green.
Fig.1
Fig.2
Fig.3
Fig.4
Summary of Contents for PES 0504
Page 1: ......
