8
E
Setting the Circulation Mode
The options available for the circulation pump are dependent on the type of pool, the
equipment installed, and the settings chosen at installation.
To set (manually activate) the circulation mode:
1.
Move the cursor over the
Status
field
(Ex:
) and press <Enter> to select
the item. The item will flash.
2.
Use the up/down arrow keys
to access the circulation
mode options.
3.
Select the desired mode and
press <Enter> to activate
the selection.
When a circulation mode is entered, either manually or as a scheduled event, circulation
pumps as well as the appropriate valve actuators will activate.
When set manually, the selected mode will run for as long as the Manual Duration (found
on device manager screen) specifies, if no other schedules are set.
To schedule the circulation mode:
Move the cursor over the circulation
folder and press <Enter> to open the
Device Manager
screen.
Pool Configuration
Circulation Mode
Additional Settings
Options
With a Two-Speed Pump
Pool/Spa with Shared Pump
and Spillover Enabled
Pool, Spa, Spill, Off
Pool LS, Spa LS, Spill LS
Pool/Spa with Shared Pump
without Spillover
Pool, Spa, Off
Pool LS, Spa LS
Pool Only
On, Off
On, Low, Off
Spa Only
On, Off
On, Low, Off
Pool/Spa with Separate Pumps
Pool Circulation
On, Off
On, Low, Off
Spa Circulation
On, Off
On, Low, Off
Main
Tue, Aug 03
2:04 pm
Air 60°
Pool 71° Spa 69°
More
Circulation Mode
Off
PS Heater
Off
Pool Setpoint 71°
Spa Setpoint 100°
Cleaner Pump
On
Pool Light
Off
Pool Light Dim
Off
Music
Off
Table Lamp
Off
Circulation Mode Off
PS Heater
Off
Pool Setpoint 71°
Spa Setpoint 100°
Cleaner Pump
Off
Pool Light
Off
Pool Light Dim
Off
Music
On
Table Lamp
Off
Main
Tue, Aug 03
2:04 pm
More
Circulation Mode
separate
Heater and set points
Pool items
PLC (X-10) items
Air 60°
Water 71°
Off