Instr 9929140
Rev 01 2018-08
Page 7 of 17
f.
Next connect the pulse bar dash switch
connector (23A) to the pulse bar connection
A
as shown. For MY19 and newer vehicles skip
step 9g and proceed to step 9h.
NOTE
For MY18 and older vehicles that are equipped with
a busbar style electrical power distribution strip you
will also need to connect the busbar adapter. Refer
to the image and procedures outlined in step 9g for
busbar connections.
g. For vehicles with a busbar you will need to first
remove the cable connection nut
E
from the
keyed power terminal
B
and install the orange
wired terminal (1B) on the busbar harness
adapter onto the keyed power terminal
B
of
the busbar. Reinstall the cable connection nut
E
and torque to specification provided.
TORQUE
36 in. lbs. (4.1 Nm)
Remove the cable connection nut
E
from the
negative terminal on the busbar and install the
black wired terminal (1C) on the busbar
harness adapter onto the negative terminal of
the busbar and loosely reinstall the cable
connection nut
E
.
Next, remove the cable connection nut from the
positive terminal on the busbar and install the
red wired terminal (1D) on the busbar harness
adapter onto the positive terminal of the busbar
and loosely reinstall the cable connection nut
E
.
h. Route the fuse block (23G) behind the pulsebar
and fasten to firewall by using a drill and 1/ 4”
drill bit to drill out the dimpled hole location as
shown in image 9f.
