2. Pop the
knockouts
out of the
rear fascia
. These snap in and out of place and can be removed by
gently pulling back on them.
3. Gently tap the very bottom of the heat shield to bend it in toward the muffler. This will create
clearance between the heat shield and your new rear bumper.
4. Slide the
top tubes
of the
bumper
through the holes in the
rear fascia
while lining up
the
bottom mounting plate
with the e
xisting threaded holes
in the frame on either side of the
hitch.
5. Start the 2 10MM Allen head bolts at the bottom bracket.
DO NOT TIGHTEN YET.
6. To make installation easier we have included 2 brackets with nuts welded to them for the top
mounts. Hold the bracket inside the
left square frame tube
where you drilled the holes earlier and
insert the included 8MM bolts with flat washers.
DO NOT TIGHTEN.
7. Repeat this step for the right side. You may find it easier to have a helper reach in above the
muffler from the
LEFT side
to hold the
nut bracket
in place while you insert the bolts and washers
from the right side.
Note:
The heat shield on the muffler is sharp. Be careful to avoid cuts when
Summary of Contents for 2015 RZR 4 900
Page 12: ...5 Place the white IQ Sticker on the Spare Tire Rack ...
Page 13: ......
