4. For slip on:
Move on to step 1 of HMF Slip on exhaust installation.
For full system:
Move on to step 5.
5. Unplug the O2 sensor from the wiring harness.
6. Remove the following:
Seats, Air intake housing, Rear close off panel, Head pipe
6. Carefully remove any gasket material left on the
cylinder head.
Installation
1. Be sure
cylinder head gasket mating surface
is clean from old gasket material.
2. Using the
supplied gasket
and original mounting bolts, install the
new HMF head pipe.
3. Install the
HMF silencer bracket
using the
top transmission mount stud
and original nut, and
the supplied
M8 20 hex bolts
,
fender washers
,
M8 nyloc nuts
and
flat washers.
Note: We have found that some frames have a hole under the plastic (leftmost arrow) and some will
have a hole where the middle arrow is. Use whichever mounting hole is present on your frame. All
will have the hole where the arrow on the right is pointing.
Summary of Contents for 2015 RZR 4 900
Page 12: ...5 Place the white IQ Sticker on the Spare Tire Rack ...
Page 13: ......
