POK SAS - 18 Cours Antoine Lavoisier - 10400 Nogent-sur-Seine - FRANCE
Phone: +33 (0)3 37 49 53 000 - Email: [email protected] - Web: www.pok-fire.com
MOP_PRO_02341_EN_A - 08/07/2021 - Cop
yright© POK S
A
S - Illustr
ations are only informativ
e
MIXY EDUCTOR
-
Eductor 400 lpm, in aluminium, male inlet and outlet couplings 2" BSP
4
Warning
1 • Note
POK SAS reserves the right to change or modify the specifications of its products at any time to incorporate
the latest technological and regulatory developments. The information contained in this document is subject
to change without notice.
2 • General Warning
Before any use or installation of POK equipment, it is mandatory to read the information
contained in this operating manual, to guarantee the safety of persons and material.
The use, maintenance, or any other operation of the equipment, must be carried out
exclusively by personnel informed of safety rules and trained in the use of this
material.
The non-compliance of safety instructions can be dangerous and cause serious bodily
harm and/or property damage.
3 • Safety
This symbol indicates important safety tips. Pay careful attention to prevent serious bodily
harm and/or property damage.
This symbol indicates instructions that must be observed to ensure smooth operation of the
device. Please always make sure to follow all the necessary precautions.
This symbol indicates useful information to know and understand the correct operation of the
device.
3.1 • General instructions
Operators should read the operating instructions written in this manual before using the eductors. They shall
not be used by people suffering from vision or hearing problems, illness or under medication.
In order to work safely, please observe the following instructions while using the material:
• Material shall be used according to the instructions written by POK in this manual.
• Systematically control the good condition of the eductors before any use.
• Any use not following the manual instructions could result in damages to people, to material or to
environment.
• Always know the hydraulic characteristics of the eductors.
• Do not unnecessarily expose people to dangerous fire conditions.
• Always open the water supply valves carefully, in order avoid any water hammer in the hoses.
• Never go over the indicated maximum flow rate and pressure, it could result in injuries to people and/or
damages to the eductor.
• Replace the instructions stickers if worn or damaged.
• The eductor shall be kept clean and protected against dust.
• Important material damage and physical injuries are to be feared in the following situations:
- Unauthorised removal of a protection part,
- Improper use of the material or in dangerous situations,
- Poor maintenance,
