Your stand mixer motor is equipped with an automatic Thermal
Protection feature which will shut your motor o if it gets too hot. Should this occur,
turn the speed selector to O , unplug the unit and allow it to cool down. It is normal for
the mixing head to become hot after prolonged use.
GB
THERMAL PROTECTION
Turn the stand mixer o and unplug it from the electrical wall outlet.
Press the attachment lock down and hold while pulling the accessory attachment out
of the hub.
USING ACCESSORY ATTACHMENT
CARE AND CLEANING
Before cleaning your Stand Mixer, ensure that the power is turned o at the electrical
wall outlet, and then remove the plug. Wipe over the outside area of the Stand Mixer
including the head and base, with a dampened cloth and polish with a soft dry cloth.
Wipe any excess food particles from the mains power cable.
We recommends to wash the mixing bowl, beater, whisk and dough hook in warm
soapy water and wipe dry - use a brush if necessary to remove any sticky food particles.
All plastic components deteriorate through prolonged dishwasher use. However, parts
of your Stand Mixer are tolerant to dishwasher use. These include the stainless steel
mixing bowl, beater, whisk and dough hook.
Note:
Place only on the top rack of the dishwasher.
Storage
Keep your Stand Mixer in a convenient position on your kitchen bench ready for use at
all times.
Place the beater, whisk and dough hook in the mixing bowl as storage of these
attachments in a drawer with other kitchen equipment may cause damage.
Note:
Never wind the mains power cable around the mixer after use as the warmth
from the motor may cause damage to it. For added convenience the unused length of
the mains power cable can easily be pushed into the base of the mixer for storage.
TROUBLESHOOTING GUIDE
Problem
Possible Cause
What to do
Motor will not start.
Motor is over-heated.
Mixer head is not locked
down properly.
Unplug and allow the motor to
cool, (the mixer head should be
cool to touch).
Move mixture in mixing bowl to
the side of the attachment, to
allow the attachment to go all
the way into the bowl.
Motor is over-heated.
Use of a high speed for a
long time.
Mixture too heavy.
Mixing quantity too large.
Unplug and allow the motor to
cool, (the mixer head should be
cool to touch).
Try mixing in batches.
Mixer head does not lock
down properly.
Attachment is hitting
the bowl.
Thick mixture is
preventing the
attachment from going
all the way down into
the bowl.
Move mixture in mixing bowl to
the side of the attachment, to
allow the attachment to go all
the way into the bowl.
Attachment is not
inserted correctly.
Mixing bowl is not locked
into the base properly.
Remove the attachment and try
inserting again. Refer to the
instructions in this booklet if
needed.
Lock the bowl into position.
Refer to the instructions in this
booklet if needed.
Mixer is moving on the
bench top.
Chosen speed is too high
for the mixture. Mixture
caught up in the
attachment.
Flour or spills on bench
top.
Lower the speed or mix in
batches.
Scrape down the attachment
and continue mixing.
Clean and dry the bench top as
well as the mixer base.
11
10
1.
2.
3.
4.
Ensure the stand mixer is turned o and the unit is unplugged.
Push up the “Attachments cover” and then press down and hold the accessory
release tab while inserting the accessory into the hub as far as it will go.
Let go of the accessory release tab and rotate the attachment slightly left and right
until you hear the locking pin click into place.
To ensure your attachment is locked into place try pulling it out while not pressing
down on the accessory release tab.
ASSEMBLING OPTIONAL FRONT POWER HUB ATTACHMENTS
REMOVING FRONT POWER HUB ATTACHMENTS
1.
2.
