10. Make sure the fasteners are in same
position as in image 8 before install-
ing the drive. Move the propeller into
vertical position and lower the drive
into place.
11. Lock the fasteners as shown above
over the lower cylinders of the Drive.
To remove the drive, make sure the
propeller is in vertical position before
raising the drive out of the well.
8. Screw in the 2 long screw into the in-
serts and screw tigh, using the allen key.
9. Do the same on the other side of the
well. If needed use the larger allen key
to tighten the large middle screw on the
fastener.
7. Put the aluminium plate with the screw
holes closer to the wall as shown above.
