Page 15
Section 3
Installation
Figure 4.4
Securing the QUICKCHIP installed
in a ZIF Socket
Figure 4.3
Aligning the QUICKCHIP 133 in a
ZIF Socket
Pin 1
Beveled Edge
& White Stripe
Installing in a ZIF Socket
1.
Make sure the side bar lever is fully rotated upward or the retaining screw is loose.
2.
With the socket in the unlocked or open position, align the pins on the QUICKCHIP 133
with the holes on the ZIF socket.
You do not need to force the QUICKCHIP 133 into
the socket.
3.
Apply gentle pressure, only if needed, to make sure the processor is completely inserted
and flush with the ZIF socket. Lower the sidebar lever or rotate the retaining screw to lock
the socket. (Figure 4.4)
Note:
If the processor upgrade is resisting, stop and check the pin alignment. If the
alignment is incorrect, remove the processor upgrade and begin the insertion again.
