Ne laissez pas les batteries
charger sans surveillance.
ATTENTION !
-4-
How to charge THE Battery
1. Make sure the voltage required for USB charging corresponds to the power source used.
2. The charger plug may overheat if overloaded. In this case disconnect the battery immediately to avoid an accident.
3. Do not let the battery charge unattended.
4. Do not use any charger or charging cable other than the one supplied with the drone.
5. Wait 30 minutes after a flight for the battery to cool before recharging.
6. Do not leave the battery in a fire, in the sun or in environments that are too hot.
7. Do not short-circuit the battery.
8. Keep the battery away from metal parts or magnets.
WARNING
1. Disconnect the battery from the R-Nano HD.
2. Gently pull out the battery.
3. Connect the USB Charger with the battery and connect the charger with a USB port or USB charging adapter.
4. Once successfully connected a red LED light will turn on indicating that charging is in progress.
5. The charging process is complete when the LED light switches off. (Charging time depends on charge level of the
battery and output Voltage / Amperage of the power supply
Gyroscopic calibration
The R-Nano HD is equipped with an auto-trim system whereby its initial settings can
be restored.
To recalibrate the drone gyroscope please follow the following steps:
1. Turn on the drone then the remote control.
2. Place the drone on a flat surface.
3. Incline simultaneously both joysticks to the left bottom position as shown on the
diagram
4. After 10 seconds return both joystick their initial position
Summary of Contents for R-Nano HD
Page 16: ......
