Trimmer Operation
Trimmer Operating Position
Before using the Trimmer, check the following:
1. The operator must be wearing the shoulder hanging Strap attached to the Trimmer, and the
Trimmer should be on operator’s right side.
2. The operator’s right hand should be holding the shaft
grip, with his or her fingers on the throttle trigger. The
right arm should be slightly bent.
3. The left hand should be holding the loop handle with
the fingers and thumb fully enclosed around the grip.
The left arm should be extended. Reposition the loop
handle up or down the driveshaft if necessary for a
comfortable position.
4. The Trimmer weight should be evenly distributed
between the arms. The trimmer head should be near
and parallel to the ground.
5. Accelerate and hold the engine at cutting speed before
entering the material to be cut.
6. Always release the throttle trigger and allow the engine
to return to idle speed when not cutting.
7. Stop the Trimmer engine when moving between work
sites.
・
If the trimmer head becomes jammed, stop the engine
immediately.
・
Make certain all moving parts have stopped and
disconnect the spark plug before inspecting the
equipment for damage.
・
Never use a String Trimmer that has a chipped,
cracked or broken trimmer head.
CAUTION
Read the Safety instructions beginning on page 2 concerning proper use of the String Trimmer.
CAUTION
Always wear gloves and protective clothing when operating the String Trimmer.
─
10
─